A "wait to start" curlyq light? Where is it?? Ford Truck Enthusiasts
What Controls The Wait To Start Light. Try it again, but this time i wait till after light goes out, then i watch to see voltmeter jump in positive direction and she starts. 2.turn the key on and look for an initial reading of 160 amps or more.
A "wait to start" curlyq light? Where is it?? Ford Truck Enthusiasts
This morning i tried to start and. Try it again, but this time i wait till after light goes out, then i watch to see voltmeter jump in positive direction and she starts. Web the pcm controls the wts light and i would guess that your wiggling the fuses caused this fuse to make contact again. Wait until the light goes off before starting. 2.turn the key on and look for an initial reading of 160 amps or more. When the ignition switch is. Web if you suspect a problem with the starting system (control box): Web the wait to start light was dim and flickering when trying to start it. Web 1.install the clamp on meter around the two output wires from the glow plug relay. For most diesels, the light turns off when the glow plugs reach the established.
It was cranking over but would not start so i had it towed home. When the ignition switch is. Wait until the light goes off before starting. Web 1.install the clamp on meter around the two output wires from the glow plug relay. Web the wait to start light was dim and flickering when trying to start it. For most diesels, the light turns off when the glow plugs reach the established. The light should always illuminate briefly, when the ignition key is in the on. This morning i tried to start and. Web if you suspect a problem with the starting system (control box): Try it again, but this time i wait till after light goes out, then i watch to see voltmeter jump in positive direction and she starts. It was cranking over but would not start so i had it towed home.
